Exfo ARU-100 HPNA Test Probe Manual do Utilizador descarregar pdf (Página 13)

ARU-100 8

NET Test

The NET Test tab allows you to view the

performance test results on the network.

³ Start Single Pair button starts a single-pair

network test between selected Device 1 and

Device 2. The single-pair test is performed with

the current parameters setup for Packet Length

and Number of Packets.

³ Start All Pairs button starts all network

performance tests for each device in both lists. The all-pairs test is performed

with default values for Packet Length = 1480 and Number of Packets = 1000.

³ Device 1/2 list all the HPNA device MAC addresses on the network to select in

the NET test.

³ View Next button sets the values in Device 1/2 to reflect the next pair in the

HPNA network, after running an all-pairs test. The button also refreshes the

Forward and Reverse values to show the results between the selected pair of

MAC addresses.

³ Test Status is Idle, In Progress, Completed or Failed for the latest

test performed.

³ Test Result displays the Forward (Device 1/Transmitter) and Reverse (Device

2/Receiver) values and pass/fail status of the following results for the

selected pair(s).

³ PER is the packet error rate.

³ SNR (dB) is the signal-to-noise ratio.

³ Data Rate (Mbps) is the data rate.

³ Attenuation (dB) is the value for the reduction in signal strength.

To select a MAC address:

1. Press the left/right arrows to highlight the Transmitter or Receiver lists.

2. Press to open the list.

3. In the list, press the up/down arrows to select the desired MAC address.

4. Press to confirm the selection and view the test status and results.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Sem comentários

Exfo ARU-100 HPNA Test Probe Manual do Utilizador Página 13