Exfo PSO-100 Series Optical Sampling Oscilloscopes Manual do Utilizador Página 115

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 114
Burst Mode Measurements
Optical Sampling Oscilloscope 107
The yellow samples are then visualized in an eye diagram in the lower
window, while the white samples are removed, according to the figure
below.
In this way, you can determine whether the burst parameters are set
correctly or not. For example, if the rise time parameter is too low, you will
observe samples in the middle of the eye, and if the trigger level is too high,
the refresh rate will become very low since it does not trig until the trigger
timeout value is reached. Depending on the burst period, you may need to
increase the number of samples/layers in the Display menu.
If the loop length is much longer, that is if the burst is longer than 1 ms, and
fills a whole batch entirely, you can use the internal clock instead of the
external clock to make measurements.
Vista de página 114
1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 139 140

Comentários a estes Manuais

Sem comentários