Exfo VDSL2 Manual do Utilizador Página 132

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 131
Wideband Tests
124 AXS-200/635
Data Rate Prediction
Summary
The Summary tab allows you to view results, change some of the variables
and Recalculate the results.
Each parameter on the pane is
described below.
³ Annex defines the modes of
available ADSL Annexes from the
ITU standards.
³ A is ADSL service functioning
over POTS.
³ B activates the ADSL
functionality over ISDN.
³ L Mask 1 assumes an increase in ADSL2 range/distance.
³ L Mask 2 also extends the signal reach but can show an
improvement in the upstream data rate.
³ M allows increased upload speeds from 1 Mbps to 3.5 Mbps.
Available only for ADSL2 and ADSL2+.
³ Technology lists the following values: ADSL, ADSL2, or ADSL2+. If
Annex L is previously selected, ADSL2 is automatically set. If Annex M,
ADSL is not available.
³ Reference Point is either CO or CPE, allowing you to select from
which end of the circuit you are running the DRP test. CO is located at
the CO/Exchange side and you are testing towards the subscriber. CPE
is the subscriber side and you are testing towards the CO/Exchange.
³ Target SNR is the desired signal-to-noise ratio ranging from 0 to 31 dB.
Default value is 6 dB.
³ Recalculate button allows you to change the setup and re-evaluate the
rates.
Vista de página 131
1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 266 267

Comentários a estes Manuais

Sem comentários