Exfo VDSL2 Manual do Utilizador descarregar pdf (Página 39)

Configure Tests for xDSL/IP Triple-Play Verification

VDSL2, ADSL2+, and IP Triple-Play Test Set 33

Configure Line Tests

Ping Test

The Ping Test tab allows you to configure the parameters to perform a ping

test, also known as an ICMP echo request, during the CPE test.

The available parameters are the

following:

³ IP Address lists either the URL or

IP Address where the unit pings.

³ URL/IP Address is the destination

IP address of the device actively

connected to the network.

³ Packet Size is a value from

through 1200 of the number of bytes sent in one packet. The default

value is 32.

³ Total Pings is the total number of ping packets to send out from

through 99. The default value is 3.

³ Timeout is the time in seconds from 1 through 15, that the unit will

wait for a response back from the destination device. The default value

is 1.

³ Max hops is the number of hops from 1 through 99, that the unit will

attempt to reach a destination IP address. The default value is 32.

To select the ping parameters to configure:

1. Press the up/down arrows to select the desired parameter.

2. Press to open the list or modify the parameter.

3. In the list, press the up/down arrows to select the function or mode.

Use the alphanumeric keypad to enter the value you want to specify.

4. Press to confirm the selection.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 123 124

Sem comentários

Exfo VDSL2 Manual do Utilizador Página 39