Exfo FastReporter Data Post-Processing Software Manual do Utilizador descarregar pdf (Página 153)

Viewing and Editing Measurements

Data Post-Processing Software 147

Viewing and Editing Measurement Identification Information

Modifying Start, Stop, and Step Values

You can modify the Start, Stop, and Step values of the iOLM configuration

file.

To modify the Start, Stop, and Step values:

1. Open an iOLM configuration file.

2. Select the configuration for which you want to modify the Start, Stop,

and Step values. You can select more than one using the Ctrl or Shift

keys.

3. In the Results window, select the Identification tab.

4. Enable the Auto-Increment option to modify the Start, Stop, and Step

values.

5. Enter the Start, Stop, and Step values for the identifiers.

Note: The Step value must be smaller than the difference between the Start and

Stop values. If the Start is greater than the Stop, then the identifier value

begins decrementing by the specified Step.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 255 256

Sem comentários

Exfo FastReporter Data Post-Processing Software Manual do Utilizador Página 153