Exfo FLS-2600B Tunable Laser Source Manual do Utilizador descarregar pdf (Página 133)

Remote Control

Tunable Laser Source 125

Programming Commands

Note You cannot use this query during a sweep.

You do not have to enter all values in the query, but you must

enter the values in the same order as in the Syntax section. If

you want to enter only some of the values, use a comma ( , ) to

separate the values, including the ones you did not enter.

For each value including units, such as wavelengths or speed,

you can specify a unit to use in the same way as the specific

queries in the previous pages. If you do not specify the units, the

system will use those that are currently set.

To specify the units, add <wsp><unit> at the end of the value

you want to modify. The <unit> parameter will be a wavelength

unit (nm or THz) or a speed unit (nm/s or THz/s).

Example A complete query:

SOUR:SWE:STEP:PROG? 1570.00,1605,50,00:050,5.500,10,1,0

A query changing only the number of cycles and trigger options:

SOUR:SWE:STEP:PROG? ,,,,12,,0

A command setting the start and end wavelengths in THz, as

well as the pause time:

SOUR:SWE:CONT:PROG? 196.7 THZ,186.8 THZ,00:200

SOURce:SWEep:STEPped:PROGram?

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 156 157

Sem comentários

Exfo FLS-2600B Tunable Laser Source Manual do Utilizador Página 133